No products in the cart.
The Puffco Peak pumps out clouds like no different, and also you’re sure to make a multitude someday. Whether or not you’re an off-the-cuff person or a heavy hitter, we’ve received you lined. We’ve laid out all of the steps and particulars to hook you up with a spotless Peak!
Table of Contents
Puffco Peak Cleansing and Upkeep: What you want
Cleansing your Peak may be very easy and may be completed with only a few home items.
- Rubbing alcohol
- Small cup for soaking
Take it aside
To start out, let’s take away the entire items of your Peak and assess the harm. Seize maintain of the atomizer and provides it a counterclockwise flip till it loosens, and take away it from the bottom. The atomizer separates into 4 completely different items however to stop any harm, Puffco recommends protecting all of it collectively and dropping it into some rubbing alcohol to soak.
In our testing, we discovered that taking it aside was the easiest way to wash out the complete atomizer. To do that, merely slip the rubber seal off and take away the ceramic bowl. Take away the ceramic bracket inside the rubber seal as properly. The ceramic bowl and plate contained in the steel housing are very fragile, so watch out and disassemble at your personal threat.
Empty the bubbler and take away it from the bottom. Gently pulling the glass down and away from the bottom ought to do the trick.
Time to soak
Fill the bubbler rather less than half manner with rubbing alcohol, cowl the opening, and shake it to loosen up any gunk inside. Chances are you’ll must let the bubbler soak in a single day to loosen up thicker oil buildup. As soon as it’s good and clear, rinse it out with recent water and set it out to dry.
Drop the complete atomizer, both assembled or disassembled, and the carb cap right into a cup of rubbing alcohol to soak for a number of hours. The tether shouldn’t want a lot consideration so set that apart for now. The alcohol will change to an amber shade because the items soak. When the soak is completed, rinse the items off with heat water and allow them to dry out.
Put it again collectively
Now that the exhausting half is over, let’s throw it again collectively! If you happen to saved the atomizer intact, merely screw it again onto the bottom and also you’re good!
If not, begin by slipping the ceramic buckle again into the rubber seal and gently inserting the ceramic bowl again contained in the steel housing. Then, place the seal again on prime by lining up the three enamel on the buckle with the gaps alongside the steel housing, and gently press collectively. Watch out with this piece – that is the place you possibly can simply break your atomizer. When completed accurately, the seal ought to be good and flat, and the ceramic bowl should not be unfastened. Now, take the complete atomizer and screw it again onto the bottom till it’s good and tight. Push down as you twist in order that the threading catches.
Lastly, take the bubbler and fill it up with water, simply previous the air holes. At all times do that away from the digital base to stop any harm. Then, take the Puffco Peak glass half and connect it again onto the bottom. The important thing right here is to ensure the underside air gap on the skin of the bubbler is lined up with the consumption gap on the bottom. Take a number of take a look at attracts to ensure the whole lot is lined up and good to go.
Run a burnoff
To complete off this deep cleansing, let’s run a fast burnoff. Flip your Puffco Peak on and toggle as much as the very best temperature setting (White). Interact the heater with a double faucet and let it run a full cycle with the carb cap off. We’ll do that a number of occasions to be thorough earlier than diving right into a recent session.
In case your Peak begins flashing a number of colours, verify the atomizer and ensure it’s tight sufficient.
Suggestions for a cleaner vape
If you end up cleansing the atomizer regularly, attempt utilizing much less materials in your classes. The candy spot is any quantity of focus you possibly can totally vaporize with none leftovers. Experiment with completely different load sizes and temperatures, and discover the mixture that gives a satisfying hit with out leaving a multitude to wash later. We additionally counsel dumping and rinsing out the bubbler after you’re completed for the day in order that nothing settles and sticks to the glass. You’d be shocked at how soiled it may get! Undertake the following pointers into your routine for a happier and more healthy Puffco Peak.
